Brick Cleaning UK: Methods, Costs and What Not to Do
Brick cleaning costs around £5 to £10 per m² before scaffolding, but the wrong method can ruin the brick. Here are the safe methods, real UK prices, how to remove efflorescence and what to avoid.
Daniel Rosser
Published 11 November 2026
Brick cleaning sounds simple: hire a pressure washer, blast the dirt off, done. In practice, it is one of the easiest ways to damage a brick wall. Brick has a hard fired face that protects it, and the wrong method strips that face away and leaves the brick soaking up water for the rest of its life. This guide covers the cleaning methods used in the UK, what brick cleaning costs in 2026, how to deal with the white salty deposits known as efflorescence, and what not to do.
The prices and advice below come from real brickwork jobs across Hampshire, Berkshire and Surrey. Costs elsewhere in the UK will vary, but the principles are the same.
How Much Does Brick Cleaning Cost in the UK?
Professional brick cleaning is usually priced per square metre. For most houses in 2026, expect to pay around £5 to £10 per m², depending on how dirty the brick is, what the dirt is made of, and how easy the wall is to reach.
| Job | Typical area | Typical cost (before scaffolding) |
|---|---|---|
| Garden wall | 10 to 20 m² | £100 to £250 (minimum charges may apply) |
| Single storey extension | 20 to 30 m² | £150 to £350 |
| Front elevation of a house | 40 to 60 m² | £250 to £600 |
| Whole house | 100 to 150 m² | £600 to £1,500 |
These figures are for the cleaning only. Very small jobs often carry a minimum charge, because the travel and set-up time is the same whatever the size of the wall.
Scaffolding is a separate cost
Anything above ground floor height needs scaffolding. That is a separate line on the quote, and it is usually £500 to £1,000 or more depending on the size of the house and how many sides need access. On a two storey house, scaffolding can cost as much as the cleaning itself.
If the brickwork is also due for repointing, doing both jobs under one scaffold saves a lot of money. Repointing costs around £60 to £80 per m², so it is worth reading our guide to repointing costs in the UK and getting both jobs quoted together.
What changes the price
- Height and access. Ground floor walls with a clear path are cheapest. Tall walls, narrow side passages and walls behind greenhouses or hedges take longer.
- Type of dirt. General grime and algae are easy. Paint, cement splashes, soot and heavy staining take more time and different products.
- Type of brick. Soft, old or handmade bricks need gentler methods, which are slower.
- Condition of the mortar. If the joints are already crumbling, cleaning can loosen them further, so repairs may need to come first.
- Area covered. A bigger job brings the rate per m² down slightly.
Brick Cleaning Methods Explained
There is no single best method. The right one depends on the brick and on what you are trying to remove.
Low pressure water and brushing
This is the safest starting point, and it is what most walls actually need. Low pressure water, combined with a soft brush and a suitable cleaner, lifts general dirt, algae and green growth without harming the surface. It takes longer than blasting, which is exactly why it works.
Biocide treatment
For algae, moss and lichen, a biocide is applied and left to work. The growth dies off and washes away over the following weeks. It is gentle on the brick and is often the only treatment needed for shaded north facing walls.
Steam and low pressure cleaning
Hot water or steam at low pressure can lift soot, grease and stubborn grime from softer bricks without the damage a hard blast causes. Specialist contractors use it on period buildings.
Chemical cleaners
Some stains, such as cement residue, rust marks and smoke staining, need a chemical cleaner. These must be matched to the brick and the stain, pre-wetted properly and thoroughly rinsed afterwards. This is not a job to experiment with, because a product that works on one brick can discolour another.
Abrasive blasting
Grit or dry ice blasting is used on some industrial and heavily contaminated surfaces. On ordinary house brick, an aggressive blast removes the protective face. We would not recommend it for a typical home.
What Not to Do When Cleaning Brick
Do not use a high pressure washer
This is the most common mistake. A powerful jet can strip the hard outer face of the brick and wash soft mortar out of the joints. Once the face is gone, the softer inner brick absorbs water, and in winter that water freezes and blows the surface off. This is exactly how spalled bricks start. The damage often does not show for a year or two, so people do not link it to the wash.
Do not use strong acid without expert advice
Hydrochloric (brick) acid is sometimes recommended online for removing cement stains. Used badly, it etches the brick, burns the mortar, leaves staining and can cause salts to appear later. It also needs careful neutralising and rinsing. If it is used at all, it should be diluted, tested on a hidden patch, and applied by someone who knows what they are doing.
Do not clean when frost is forecast
Wet brick that freezes can crack. Clean in spring, summer or early autumn, and give the wall time to dry out fully before the cold arrives.
Do not clean crumbling mortar and hope for the best
Washing a wall with failed joints pushes water straight into the structure. If the pointing is in poor condition, check our guide to the signs your house needs repointing before you clean anything.
Do not seal brick straight after cleaning
Some people rush to apply a sealer to keep the wall looking clean. Sealing can trap moisture inside the brick, which makes frost damage more likely. Brick needs to breathe. Get advice before applying any coating.
Efflorescence on Brick: What It Is and How to Remove It
Efflorescence is the white, powdery or crystalline deposit that appears on brick and mortar. It is not mould and it is not paint. It is salt that has been carried to the surface by water and left behind as the water dries.
Why it appears
- New brickwork. Fresh bricks and mortar contain salts and a lot of water. It is common in the first year and usually fades by itself.
- Persistent damp. Leaking gutters, defective flashing, blocked drains or raised ground levels keep pushing water through the wall.
- Failed pointing. Open joints let rain in, and the water carries salts out through the bricks.
How to remove it
- Brush it off dry. Use a stiff nylon brush, not wire, when the wall is completely dry. On new walls this is often enough.
- Repeat as needed. Salts can keep appearing for several weeks. Brush them off each time rather than wetting them, which only dissolves and redistributes the salt.
- Use a proper efflorescence cleaner if it persists. Choose a product made for brick and follow the instructions. Test it on a small hidden area first.
- Fix the cause. If it keeps returning, there is a damp problem. Check gutters, downpipes, flashing and the pointing, and make sure the ground level is below the damp proof course.
Removing efflorescence without dealing with the water source is a temporary fix at best. The salts will come back.
DIY Brick Cleaning or Hire a Professional?
A sound, ground floor wall with light algae or dirt is a reasonable DIY job. You need a soft brush, a hose, a suitable cleaner and plenty of patience. Always test a small patch first and stay away from high pressure.
Call a professional when:
- The wall is above ground floor height and needs scaffolding or ladders.
- The bricks are old, soft or handmade.
- You are dealing with paint, cement, soot or heavy staining.
- The mortar is crumbling or the bricks are already flaking.
- Efflorescence keeps returning.
Finding Brick Cleaning Near You
If you search for brick cleaning near me, you will find general cleaning firms, roof cleaners and brickwork specialists. The difference matters. Ask any contractor:
- What method they will use, and why it suits your bricks.
- Whether they use high pressure. If the answer is yes, ask for a different quote.
- Whether scaffolding is included or listed separately.
- Whether they carry public liability insurance.
- Whether they will check the pointing before they start.
Get at least two written quotes and compare the price per m², not just the total.
Need a Professional?
Rosser Brickwork & Repointing Services covers brick cleaning, repointing, brick restoration and chimney work across Hampshire, Berkshire and Surrey. We are a fully insured, specialist brickwork firm, and quotes are free with no pressure.
To get a quote, message us on WhatsApp or visit rosserbrickwork.co.uk. For a rough idea of the repointing element of your job, try our repointing cost calculator.
Frequently Asked Questions
How much does brick cleaning cost per m²?
Around £5 to £10 per m² in 2026, before scaffolding. Scaffolding is usually a separate £500 to £1,000 or more.
Is it safe to pressure wash brick?
Only at low pressure and with care. High pressure can strip the protective face of the brick and wash out the mortar, which leads to water damage and frost damage later.
What is the white powder on my bricks?
It is usually efflorescence, which is salt brought to the surface by moisture. Brush it off dry and find out where the water is coming from.
Will cleaning make my bricks look new again?
It will remove dirt, algae and many stains, but it will not reverse weathering or damage. Some stains never fully lift, and old bricks should look aged rather than brand new.
When is the best time of year to clean brickwork?
Spring to early autumn, when the weather is dry and mild and the wall has time to dry before frost.
Should I repoint before or after cleaning?
Usually clean first, then repoint, so the new mortar stays clean. If the joints are failing, repair them first so cleaning does not push water into the wall. A specialist can advise on the order for your house.
Free Tool
Work Out Your Own Repointing Cost
Put in your wall measurements and get a cost range built from the real rates on this page — £60–80 per m² — with scaffolding shown as its own separate line rather than hidden in the total.
Open the Cost CalculatorNeed a Professional?
Get a Free Quote from a Brickwork Specialist
If you're in Hampshire, Berkshire or Surrey, Rosser Brickwork & Repointing Services Ltd can handle your repointing, chimney repairs or brick restoration. Fully insured, free quotes, no pressure.